Electrostatic powder coating oven; powder coated material enters the powder coating oven after powder coating booth. Powder adheres to the material in the powder coating oven. Powder coating oven degree may vary according to the chemical reaction properties and material thickness.

Thermoblock

The oven heating is provided with NG energy burner. Burning of the burner is done in thermoblock. Thermoblock, is made of h 310S quality stainless steel. The hot air circulated by fans in the oven. Oven capacity is 250ºC degree. Temperature control is done from the control panel of the oven. The heat reaches the set temperature, the burner flame is automatically lowered. If the loss of heat, the burner is automatically activated. With this system the energy loss is minimized. 


Thermoblock

Panel (Construction Part)

The oven wall is composed of panels. The panels provide heat to remain in the oven. There are rock wool in the panel. Thickness of the rock wool 50 mm the density is 70. The outer surface of the panel Produced by 1 mm thick steel sheet. The inner surfaceof 1.2 mm galvanized steel sheet Produced by the panel. Assembly of the panels is easy and the heat-resistant silicone is used between the two panels. 

There is a air circulation fans for circulate the hot air in the oven.

Thermoblock Control Door

There is a thermoblock control door avaible to reach easy to thermoblock. The door is easy to ensure a response to the malfunction of the thermoblock. Doors isolated with rock wool.



Burner

DIN 4787-4788 and Europanion Standarts
CE Certificated
Low emition
Silent work
Best Design
High Performance
High Technology